Social Icons

Sunday, March 17, 2013

[WIP] 1/100 VP Strike Freedom Part 2

Restarted on this project when I started on it end of 2012. Been sitting on my table for almost 3 full months while I worked on other kits. Time to give it the attention it needs :D

Start of with the most dreaded part of MG Strike Freedom kit... long and deep seamlines, and not to mention a whole load of them.


Took about a week of sanding and filling to achieve satisfactory results after priming.
But there's still some minor irregularities that require touchup.


The dragoon holders each have a small resin part attached to it, secured with pin and superglue.

No comments:

Post a Comment